Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 - Manual (Page 67)

SierraNet M168 User Manual 65
Trigger and Filter Settings in Easy Mode Teledyne LeCroy
Figure 2.39: Analyzer Trace Capture Display
For details about the results display, see “Display Manipulation” on page 143 and see
“Preferences” on page 176 .
2.6.3 Patterns and Data Capture Setup
You can refine data capture by choosing Pattern and then selecting specific patterns for
capture. Additionally, you can define a different set of patterns to capture after trigger.
The Trigger and Filter settings dialog allows you to set the parameters for triggering on
selected triggers and filtering in (including) or filtering out (excluding) selected patterns.
Refer to
“Trigger and Filter Settings in Easy Mode” on page 57 .
2.6.4 Pre- and Post Trigger Data Capture
Move the Trigger Position slider button (see Figure 2.29 on page 57 ) to define one set of
patterns for capture prior to the occurrence of a trigger (left of the slider) and another set
of patterns for capture after the occurrence of a trigger (right of the slider). The selection
and setup procedure is the same for both Pre‐Trigger capture and Post‐Trigger capture.
(see
“Trigger Setup” on page 131 ).
2.6.5 Ethernet Patterns (Easy Mode)
The application provides User Patterns and a library of Preset patterns.