Teledyne LeCroy SierraNet M168 User Manual Ver.1.50 - Manual (Page 34)

Teledyne LeCroy Protocol Analyzer
32 SierraNet M168 User Manual
Figure 1.25: Info Dialog
Then the update is complete. The connection may freeze when the unit reboots after the
firmware update. Perform the following steps to recover:
1. Click OK on the error message in the Info dialog.
2. Click Close to close the Device Setup dialog.
3. Click Refresh Device List in the Device Management dialog (see
Figure 1.20 on
page 27 ).
4. Click Disconnect.
Figure 1.26: Device Setup Dialog with OK Device Status
Note: Do not shut down or power cycle the analyzer during this process.
1.7 Protocol Analyzer
To use the software for protocol analysis, first select File > New Project for a new project
or File > Open to open an existing protocol analysis .gep file. (see
“Protocol Analysis” on
page 35. ) You can also open a .get example file. Example files are in the Examples folder.
You can also select File > Recent Projects to open a project you had recently saved.