Teledyne LeCroy Merlin - Users Manual - Manual (Page 25)

17
Merlin Protocol Analyzer User’s Manual CATC SW Version 2.0
RS232 to USB converter [d].
Step 3 Connect the connector marked with ‘COM B’ in the
HCITrace RS-232 Cable [c] to ‘Connector B’ in the 2-port
RS232 to USB converter [d].
Step 4
Connect the USB cable [not shown] to the USB connector of
the 2-port RS232 to USB converter [d].
2-port RS232 to USB converter
The 2-port RS232 to USB converter [d] allows the user to connect two serial
connectors to the host machine via a single USB connection. When
connected to the host machine the converter emulates two separate virtual
COM ports that can be used as other real COM ports. Prior of using this
converter as part of the HCI probe several drivers need to be installed. The
drivers are provided on the installation CD-ROM in the HCI Probe\Drivers
sub directory.
Once the converter is connected to a host machine the user is prompted to
provide the place where the system can install the drivers from.
After installing the drivers two new COM ports are going to be available, as
seen in the following snapshot of the Device Manager.