Teledyne LeCroy Merlin - Users Manual - Manual (Page 166)

158
Merlin Protocol Analyzer User’s Manual CATC SW Version 2.0
Step 5
Click the button marked New.
The following dialog box appears.
Step 6
Enter the appropriate Personal Identification Number (PIN)
for the selected device to the box marked PIN Code. This
PIN allows Merlin to learn the Link Key. If you do not have
the PIN, skip to Step 5.
Note The PIN you provide should be the same used by the Slave. For example, if your
Slave device requires a PIN of "1234", then enter the same PIN in the dialog box
shown above.
Step 7 If you do not have the PIN, or if the Master and Slave have already
agreed upon the Link Key, manually enter a Link Key as a 128 bit
(sixteen byte) hex value into the box marked Current Link Key. If
you have the PIN, you can skip this step.
Note If the Master and Slave were previously connected, they may already agree on the
Link Key. In this case, you will need to provide Merlin with the Link Key and not
simply the PIN.
Step 8
Click OK
The changes you have made are applied and the information is displayed
in the Slave Encryption Setup dialog box as shown previously.
Step 9 Click OK.
The Slave Encryption Setup dialog box closes. Within the Device List,
you should see a "Yes" in the Security field for the selected device.