Teledyne LeCroy Merlin - Users Manual - Manual (Page 19)

11
Merlin Protocol Analyzer User’s Manual CATC SW Version 2.0
2.4 Setting Up the Analyzer
Step 1
Attach the Antenna to the ANT connection point. The antenna
should point up.
Step 2
Connect the provided AC power cord to the rear of the analyzer and
to a 100-volt to 240-volt, 50 Hz to 60 Hz, 100 W power outlet.
Note The analyzer is capable of supporting supply voltages between 100-volt and
240-volt, 50 Hz or 60 Hz, thus supporting all known supply voltages around the
world.
Step 3
Turn on the power switch on the rear of the analyzer.
Note At power-on, the analyzer initializes itself in approximately ten seconds and
performs an exhaustive self-diagnostic that lasts about five seconds. The Trigger
LED illuminates during the power-on testing and turns off when testing is
finished. If the diagnostics fail, the trigger LED blinks continuously, indicating a
hardware failure. If this occurs, call CATC Customer Support for assistance.
Step 4
Insert the Merlin CD into the CD ROM drive of the PC that will be
administering the analyzer.
Step 5 Connect the USB cable between the USB port on the back of the
analyzer and a USB port on the analyzing PC.
The host operating system detects the analyzer and begins to install the USB
driver.
Step 6
Follow Windows on-screen Plug-and-Play instructions for the
automatic installation of the Merlin Analyzer as a USB device on
your analyzing PC (the required USB files are included on the
Merlin CD.
2.5 Installing the Analyzer Software on the PC
Once Merlin has been recognized as a USB device, install the Merlin
software on the PC administering the analyzer.
Step 1 On the PC, run setup.exe on the installation CD and follow the
on-screen installation instructions.
The Merlin application will install on the PC hard disk.
Step 2
To start the application, launch the CATC Merlin program from the
Start Menu: Start>Programs>CATC>Merlin.