IAI America IA-T-XA (ANSI standard CE mark agreement) - Manual (Page 24)

Mode Selection screen
This screen becomes the basic screen for all
operations.
Press the F1 (Edit) key.
* When you make a selection error or input error, press the ESC key to return to the last
screen and continue operation. Pressing the ESC key once or several times during an
operation can return to the basic screen shown above without fail.
Edit mode screen
Press the F1 (Posi) key.
Posi (position data) edit screen
Press the F1 (Mdi) key.
The figure above indicates the case of a two-axis
controller. Nothing is displayed in the sections for the
3rd- and 4th-axis data.
Position No. input mode
The cursor is located at the position
No. When no data is input, X.XXX is
displayed. Press the return key to
move the cursor to the section of the
position data for the 1st axis.
* When data is already input, overwrite
it (the original data is lost) or use the
PAGE UP and PAGE DOWN keys to
move to the screen with X.XXX
displayed and input data.
Pressing the F1 (Clr) key twice clears
the input data for all axes. This key
clears the controller’s data even if the
WRT key is not pressed.
Position No.
1st axis data 2nd axis data
4th
axis
data
3rd
axis
data
Deceleration data Velocity data Acceleration data
21