IAI America RCS2-TFA5N - Manual (Page 50)

10. Maintenance and Inspection
44
[How to apply grease for guide rail]
1) Turn off the power and pull out the table.
If the lead is too small to move the table, insert a screwdriver, etc., into the cutout groove provided in the
shaft on the rear side and turn. [Refer to “How to Move Table by Hand.”]
2) Wipe off the grease attached to the V-groove in the guide rail and apply the specified grease.
3) Move the table to spread the grease evenly
Actuator
Table
Table Guide rail V-groove (2 locations) Actuator Guide rail V-groove (2 locations)
Front Rear