IAI America RCS2-TFA5N - Manual (Page 30)

6. Installation
24
Front plate
Top side of table
Caution: x A work part shall be mounted on a machined plane or a plane with equivalent precision,
and the flatness shall be 0.01 mm/m or less.
If sufficient flatness is not secured, the table is deformed when mounting and fixing a work
part, causing malfunction.
Flatness refers to the height difference between the maximum value (peak) and minimum
value (trough) of surface distortion.
x The length of screws used to mount a work part must the effective screw depth described
here or less.
If a screw is screwed in more than the effective screw depth, the end may get into contact
with the guide rail and the table may be deformed, causing malfunction.
71 69
26
35
48
48
26
11
36
16
φ5
0
+0.03 depth 5
4-M5 depth 12
5
0
+
0.03
6
depth 5
28
10
76
48 56
5
0
+0.03
6
φ 5
0
+0.03
4-M5
depth 5
depth 5
depth 8