IAI America RCS2-TFA5N - Manual (Page 46)

10. Maintenance and Inspection
40
10.3 Cleaning
x Clean exterior surfaces as necessary.
x Use a soft cloth to wipe away dirt and buildup.
x Do not blow too hard with compressed air as it may cause dust to get in through the gaps.
x Do not use oil-based solvents as they can harm lacquered and painted surfaces.
x To remove severe buildup, wipe gently with a soft cloth soaked in a neutral detergent or alcohol.
10.4 Inspection of the Interior
When inspecting the interior, check the items specified below.
Main unit Loose actuator mounting bolts, other loose items
Ball screw/guide rail Lubrication, buildup
[Internal inspection of ball screw]
Turn off the power and pull out the table.
If the lead is too small to move the table, insert a screwdriver, etc., into the cutout groove provided in the shaft on
the rear side and turn. [Refer to “How to Move Table by Hand.”]
Visually check the lubrication condition of the ball screw.
Even when the grease is brown, the screw is lubricated property as long as the traveling surface looks wet and
shiny. If the grease is mixed with dust and dirty or has no shiny appearance, or if the grease has lost its efficacy
due to prolonged use, clean the applicable area and then replenish the grease.
Spiral cover