SKC 210-1000 Pocket Pump - Manual (Page 7)

5
5. If replacing the battery, unplug the old battery pack by
carefully lifting it upward, and remove it from the pump.
6. Align the jack on the new/replacement battery pack with
the pins on the pump. Press into place. Replace the battery
compartment cover and belt clip removed in Step 4.
7. Turn the pump over so that the LCD faces upward.
Replace the two screws on the front panel of the
pump (do not overtighten the screws). Replace
the keypad cover by aligning it with the ridges
on each side of the keypad, pressing it down, and
pushing it upward.
For subsequent charging, charge battery pack
attached to the pump (see page 6).
min
Do not charge or operate the pump with the charger in hazardous locations.
Use only the SKC-approved battery pack designated for the Pocket Pump to
ensure reliable performance and to maintain the SKC warranty and UL Listing
for intrinsic safety.
Use only the SKC-approved chargers to charge this pump.
Battery Installation/Charging