SKC 210-1000 Pocket Pump - Manual (Page 11)

9
Introduction
Interpreting Pump Operating Terms
In this manual, “run time data” refers to all the terms listed below:
FLOW: Flow rate in milliliters per minute (ml/min)
VOLUME: Total volume of air in milliliters (ml) or liters (L) since reset
PRESSURE: Pump back pressure measured in inches (ins) of water or millimeters
(mm) of Hg
TEMP: Temperature of incoming air in C or F
RUN TIME: Time pump has run in minutes (min) since reset
FAIL:
A type of fault indicating insuffi cient battery capacity (see page 7)
Interpreting the LCD
Operating Indicators
PROG: Active when a program is loaded into the Pocket Pump memory by
DataTrac
® Software
HOLD: Active when the Pocket Pump is in HOLD mode
ADJ: Active when the Pocket Pump is being fl ow calibrated
FLOW: Active when the LCD shows the fl ow rate
VOL: Active when the LCD shows the volume of air pumped
SET: Flashes when setting the fl ow rate
Icons
Flow Fault: Flashes during fl ow fault (see graphic below and page 11)
Battery:
Shows battery charge status (see graphic below and page 8)
Operating indicators
Flow fault
Battery charge
level
Numerals
PROG HOLD ADJ FLOW VOL SET
C F ins mmL/min
Display units
Flow Fault Icon
Battery Icon