SKC 210-1000 Pocket Pump - Manual (Page 6)

4
Installing/Replacing the Battery Pack
1. Completely charge the new battery pack detached from the pump
(see page 6). This initial slow (16-hour) charge will provide op-
timum battery performance. Following charging, install the new
battery pack.
2. Press down on the sliding keypad cover near the SKC logo. Push
the keypad cover down and away from the display until it is free
from the pump case.
3. Lay the pump on a fl at surface with the LCD
facing upward. Remove the two screws on the
front panel of the pump.
4. Turn the pump over so that the LCD faces down. Remove the
belt clip by unscrewing the single locking screw, and remove
the battery compartment cover.
min
The use of a repaired or rebuilt battery pack voids any warranty and the
UL Listing for intrinsic safety.
Battery Installation/Charging
To enhance batt ery life, SKC ships batt ery packs separate from the pump.
Completely charge a new battery pack detached from the pump before installing.