SecurityMan NDVR-04 - Manual (Page 7)

7
Video Output connection to TV or monitor
Please connect camera video cable to the DVR video input port. This unit provide 4 x
BNC video input connectors port. The camera installation procedures are as following:
Connecting the camera video: connect the camera video cable to the DVR's VIDEO-IN.
Connecting the camera power: connect camera’s A/C adapter to the camera, and plug the
adaptor into a power outlet. The complete connection illustration with a camera are
shown in the figure below.
Please connect the TV or monitor input source to the video-out located on the back of the DVR.
This unit provide an S-Video and 2BNC output connectors. Video output are used primary for
monitoring and toggle between full screen and quad screen display. The call out connector is used
for a 2nd or a son-monitor output to display full screen single channel with auto sequencing mode,
no quad view. The figure below illustrate the connection between the DVR and the monitor output.
DVR Installation
Video Input connection (Camera Input)
Out to TV
S-Video out to TV
Signal line
Camera
Power line
AC/DC adapter
Power outlet