Securitron DK-26PBK - Manual

Securitron Magnalock Corp. www.securitron.com
ASSA ABLOY, the global leader
Tel 800.624.5625 [email protected]
in door opening solutions
© Copyright, 2011, all rights reserved PN# 500-17000
Page 1 Rev. D, 03/11
SECURITRON MODEL DK-26PSS, DK-26PBK KEYPAD
INSTALLATION INSTRUCTIONS
The DK-26P series is the keypad portion of Securitron’s DK-26 digital entry system. It is
purchased either to add a second keypad or to replace a failed keypad in a DK-26 installation.
The part number DK-26PSS calls out brushed stainless steel finish. DK-26PBK calls out black
powder-coat finish.
Please note that since 1984, Securitron has manufactured a number of other digital entry
keypads which employ a separate keypad and CPU board. The part numbers of these older
products are: DK-10, DK-20, DK-20+ and DK-25. The DK-26P series keypad is not compatible
with any of the older CPU boards. It works only with the DK-26 CPU board. This is because the
older products employed keypads with pairs of keys being read as a single input so there was a
total of five inputs for the keypad and CPU board (not counting the Bell key). The DK-26 system
is a true ten digit product with ten separate inputs.
For addition of a second keypad in a DK-26 installation, it’s just a matter of connecting the
keypad wires to the CPU board in parallel with the first keypad. Two wires will be on each
terminal. Two keypads are the maximum that can be used in this way.
For replacement of the keypad in a DK-26 installation, it’s just a matter of disconnecting
the old keypad from the terminal strip on the CPU board and connecting the new one. If you
don’t have your DK-26 manual, the drawing below shows the connections.
GR N YEL RE D BLU WH T BLK GR Y BR N BGE ORG PNK VIO
BEE
PER
CO
M
M
O
N
RE
D LE
D
GR
N
L
E
D
YEL
L
E
D
KEY
S
KEY
S
KEY
S
KEY
S
KEY
S
KEY
S
KEY
S
VI
O
L
ET
PI
N
K
OR
A
N
G
E
BEI
G
E
BR
O
W
N
GR
A
Y
BL
AC
K
WH
IT
E
BL
U
E
RE
D
YEL
L
O
W
GR
E
E
N
KEYPAD CABLE