Securitron PB22 User Manual
Page 2
PN# 500-23160
Page 2
Rev. C, 11/11
the LED which then can be pulled out from the block. Note: LED is polarity sensitive. Insert
new LED into contacts, the
should be on the side of the green wire with printing facing the
same directions as the switch block terminals. Operating Life of the switch LED is 100,000
hours.
For LED replacement in older PB22: The switch LED assembly is replaced by snapping out the
contact block assembly at the rear of the switch. This reveals the LED assembly which then can
be pulled out from the block. Note: LED assembly is polarity sensitive. Insert the new LED into
contacts, the
should be on the side of the green wire with printing facing the same directions
as the switch block terminals.
MOMENTARY RELEASE OF FAIL SAFE OR FAIL SECURE ELECTRIC LOCK
ELECTRIC
D.C. LOCK
IF FAIL SAFE
IF FAIL SECURE
BLUE
POWER
SUPPLY
+
+
+
_
_
PB22
POWER
SUPPLY
TIMEMATE
YELLOW
WHITE
GREEN
RED
BLACK
_
+
_
+
TIMED DOUBLE BREAK RELEASE OF FAIL SAFE LOCK
WHITE
RED
BLACK
YELLOW
BLUE
GREEN
WHITE
RED
FAIL SAFE
D.C. LOCK
BLUE
Y
E
LLO
W
G
R
EEN
PB22
NOTE: Both configurations allow for one SPDT dry contact for integration into an
access control or monitoring system.
4. ALTERNATE LENS CHANGING
The pushbutton is factory shipped with the green lens set installed and two lens/insert options.
Changing to the other lens sets is simple.
1) Grasp keyplate and turn over. From the back rotate the white contact block of the switch
counter-clockwise to the 11 o’clock position and pull straight back to remove the contact
block.
2) With a slender smooth ended object such as a marker pen, slide it inside the switch body.
With the object inserted in the switch up against the lens, place the object on a smooth
surface with the keyplate on top, and tap the keyplate up and down on the object to pop
the lens off. Remove the lens and insert.
3) Turn the keyplate over and place the new insert onto front of switch, confirm that the text
on the insert is correct reading to the keyplate and place the matching colour lens on top of
the insert and compress around all edges of the lens until it snaps in place. Depress lens
several more times to ensure smooth operation and that the lens is not binding.
4)
With the terminals upward insert the contact block back into the back of the switch at the 11 o’clock
position and rotate clockwise until it stops straight up and down.