Securitron PB2-LK User Manual
Securitron For Home
Securitron Magnalock Corp.
www.securitron.com
ASSA ABLOY, the global leader
Tel
800.624.5625
in door opening solutions
© Copyright, 2011, all rights reserved
PN# 500-11550
Page 1
Rev. C, 05/11
SECURITRON PB2-LK ILLUMINATION KIT
1. INTRODUCTION
The PB2-LK is a field installable illumination kit intended for the PB2E/PB5E/EEB2 series push
buttons.
2. PRODUCT OVERVIEW
Upon unpacking this product, an inventory should be made to ensure that all the required
components and hardware have been included. Along with these instructions, the PB2-LK
product should include the following items:
Part#
Description
Quantity
030-14600 LED
1
540-32180
Green Wire w/ Resistors
1
540-16600 Black Wire
1
3. INSTALLATION INSTRUCTIONS
Remove the switch assembly by twisting it counter-clockwise about 20 degrees and then pull the
switch out. Remove old LED if installed by pulling straight out. Insert the LED with the printing
facing up towards the top of the switch as shown in Figure 1. This is important to maintain the
polarity of the LED and to prevent any damage. Re-attach the switch assembly to the main push
button body.
PRINTING
W
1
TOP OF SWITCH
Figure 1
Connect the two wire assemblies by pushing the connectors onto the spade terminals as shown
in Figure 2. A resistor is installed on the green wire so that the LED may be operated on either
12 or 24 VDC. If the power supply is 24 VDC, connect directly to the wires. If the power supply
is 12 VDC, remove the resistor for proper operation at the lower voltage. Apply the 12VDC or
24VDC voltage to the green and black wires to verify operation.
Figure 2
REAR OF UNIT SHOWN
BLACK
GREEN
REMOVE RESISTOR
FOR 12 VDC
OPERATION
TOP OF SWITCH