Securitron SWK User Manual
Page 2
PN# 500-22930
Page 2
Rev. B, 08/11
SOLAR WIND KIT INSTALLATION
The following exploded illustration Figure 1 shows the included hardware required to properly
install a SWK to a PV array panel mounted to a vertical pole. (20 Watt PV array panel shown).
Figure 1
1. Insert the square nuts into the cutouts
at each side of the panel and slide in
slot to initial position.
2. Assemble swivel brackets with the
included hardware to the nuts.
3. Tighten screws securely when brackets
are adjusted to the desired position.
Figure 2
2X PANEL
SUPPORT
ARM
6X 10-32 X 7/16
LONG PPH SCREW
6X #10 PLAIN
FLAT WASHER
(REFERENCE) EXISTING
PV ARRAY PANEL
MOUNTED TO POLE
- NOT INCLUDED
PANEL MOUNTING
CROSS MEMBER
2X PANEL MOUNTING
SWIVEL BRACKET
(SEE FIGURE 2)
1/4-20 U-BOLT
2X 1/4 PLAIN
FLAT WASHER
2X 1/4-20 HEX
LOCK NUT
4X 10-32 HEX
K-LOCK NUT
- ASB_Series (2 pages)
- ASCWB-DM62CL (4 pages)
- CWB_Series (2 pages)
- EASB_Series (4 pages)
- GDB (2 pages)
- HHD (6 pages)
- IK_Series (3 pages)
- M34R_Series (10 pages)
- M370 (16 pages)
- M38 (L, S and LS with D and T Options) (14 pages)
- M38 T UPGRADE (2 pages)
- M380BD_C_C2_X MAGNALOCK_Series (20 pages)
- M670 (16 pages)
- M680BDCX (16 pages)
- M32 (16 pages)
- Z-32 (2 pages)
- ZA-32 (3 pages)
- UHB (2 pages)
- TJ-38 (7 pages)
- TDK-1 (1 page)
- SWB-03 (2 pages)
- SMLS_SMSS (4 pages)
- SAM2C-24 (1 page)
- SAM2-24 (11 pages)
- SAM (16 pages)
- 32 REPLACEMENT STRIKE (1 page)
- UNL-12 UNLATCH (10 pages)
- STK-1 (2 pages)
- MUNL-12 (11 pages)
- MM15-TS (1 page)
- MM15 Z-Bracket_Series (1 page)
- MM15 (2 pages)
- Blind Nut (1 page)
- FSUNL_Series (2 pages)
- SCL-12 (4 pages)
- MCL-24 (8 pages)
- SPK (2 pages)
- SASM KIT STRIKE (1 page)
- GL1 Quick Start (1 page)
- GL1 Install (10 pages)
- FMK-SW (7 pages)
- BPSS-10 (7 pages)
- PB5E (2 pages)
- PB5 (2 pages)