Securitron ASCWB-DM62CLM - Manual (Page 3)

PN# 500-22800
Page 3 Rev. C, 06/11
4.2 WOOD FRAME MAGNALOCK MOUNTING
Mounting the spacer bracket onto a wood frame header requires the use of the six (6) wood
screws provided. The wood screws mount through the frame and extend into the internal
header to ensure a safe and secure mounting of the Magnalock reducing the possibility of the
Magnalock becoming loose during regular use. Figure 4 illustrates a visual concept of the
parts that will secure the bracket for the Magnalock installation.
Figure 4
While installing the spacer bracket onto a wood type frame, follow the Step-By-Step
procedures listed below:
 Position the bracket in the desired location on the frame with the “T” shaped slot facing
downward and to the back side location of the DM62 Magnalock aiming away from the
opening.
 Utilizing the spacer bracket as a template, mark the six (6) counter-sink holes where the
wood screws will be located.
 Drill the six (6) marked locations in the frame using a 7/32” [5.5mm] drill to a minimum
depth of 2-1/2” [64mm].
 Mount the bracket onto the frame and securely tighten using the six (6) wood screws
provided.
 Drill the hole for the cable access into the frame utilizing the slotted area provided in the
center of the spacer bracket.
 Position the DM62 Magnalock onto the spacer bracket while running the cables through
the cable access hole and access panel area.
 Using the eight (8) long socket head cap screws provided with the bracket hardware and
the eight (8) flat washers provided with the DM62 Magnalock hardware, securely mount
the Magnalock into place.
NOTE: APPLYING FOUR (4) ADDITIONAL SHEET METAL SCREWS INTO THE
REMAINING BRACKET MOUNTING HOLE LOCATIONS IS RECOMMENDED.
Aluminum Spacer Bracket
(Included)
DM62 Magnalock
(Sold Separately)
(8X) Socket Head Cap
Screw, Long
(Included)
(8X) Flat Washer
(Included with DM62)
(6X) Wood Screw
(Included)