RECON 26419 Xenon Strobe Light Kit User Manual
Page 8
‐
Using Tape or A Washable Marker, Mark Out The Area Where The Seat
Comes In Contact With Floor, Also Observe Any Obstructions That Will
Interfere With Power Supply. That Includes And Wires or Mechanisms
That Moved While Adjusting The Seat.
‐
Once The Desired Location Is Discovered, Run All Cables Through The
Firewall To Area Around Power Supply. Again, Making Sure Not To
Interfere With Seats Function.
‐
Based Off of Chart Below Determine The Size Of Wire Used To Power &
Ground The Power Supply. Be Sure To Install A Fuse (Not Included In this
Kit) Within 1 Foot Of 12V+ Connection To The Battery.
‐
Run The Positive & Negative Wires Through Location In Fire Wall, Leaving
Positive & Negative Wires Disconnected.