RECON 26419 Xenon Strobe Light Kit - Manual (Page 2)

Tools Required:
- A Good Assortment of Hand Tools is Recommended, Required Hand tools
are as Followed:
• Cordless Drill
• 1 Drill Bit Sizes - 1/8"
• 1 Hole Saw (1”)
• Phillips Bit
• Wire Strippers & Crimper's
• Screw Drivers Phillips
• Electrical Tape
• Heat Shrink
• Hot Glue Or Silicone
• Stranded LV Wire (Spec'd At Least At 20 Amp)
• Choice of Connectors +/- Soldering Tools
On To The Tear Down.
• It Is Not Required, but Disconnecting Your Batteries Negative Cable Is
Recommended
Start by Removing The Tail Lamps
‐
Most Applications Will Have 2 Bolts or Screws Found By Lowering The Tailgate
‐
Then Pull Housing Out Of The Snap Locks
‐
Disconnect Bulbs and Set Aside (Be Careful Not To Damage Bulbs)
Place Them On A Workable Surface