RECON 264155_264156 Cab Lights (Chevy-GMC) - Manual

RECON Truck Accessories 09/05 Page 1 of 4 Installation Instructions Part # - 264155 Series
RECON 3-Piece Cab Roof Light Installation
Test Vehicle: (2003 Chevrolet/GMC 2500HD)
Email:
[email protected] Website: http://www.reconaccessories.com
This document covers the installation of RECON Truck Accessories 3-Piece running
lights on a 2003 Chevrolet/GMC Silverado/Sierra 2500 HD
RECON 3-piece Chevy/GMC Cab Roof Light Kit Boasts The Following:
Meets S.A.E. specifications
Adapts to Curved and Flat Roofs
Kit includes 2 Corner Clearance Lights and 1 Middle Lamp Cluster Center Marker Light
Complete Wiring Harness with Quick Wire Connectors
Great Retail-Friendly Packaging
All Necessary Hardware
The light kit comes with everything required to install, except it is also recommended that you apply a little
silicone/sealant to ensure a lasting seal around the holes & wires.
Overview
The installation takes approximately 2 to 3 hours and can be broken down into 5 main steps:
1. Drop front part of headliner
2. Measure/Mark holes for lights
3. Mount
Lights
4. Wire Lights
5. Re-assembly
Drop Headliner
• Remove sun visor assemblies and sun visor clamp (Torx 15 & 20 required)
• Disengage passenger side grab handle. Insert small flat screwdriver to pull out covers/lock
mechanism then pull out on handle until you feel it disengage. There is no need to remove
handle from headliner.
• Disengage DS and PS pillar covers. Pull out at top and away from pillar. Lower panel(s) down
so you can drop headliner about 4-6”.