RECON 264150 Backup Projector Lamps DIY User Manual
RECON For the car

Page 1
In This DIY We Will Show You How To Install Recon Backup Lamps (part # 264150 To Run On A Separate Switch & In Reverse.
Please Note, There Are Many Ways of Installing These Lights, Including Wiring Methods, Wiring Connectors, And Other Variables
_________________________________________________
- Go Over The Parts Included In The Kit That You Received – Confirm All Items Are In The Box.
You Should Have
-
2 Projector Lamps
-
1 Switch
-
Wire Harness
________________________________________________________
Tools Required:
A Good Assortment of Hand Tools are Recommended, Required Hand tools Are As Followed:
-
Drill
-
Drill Bit Set
-
Phillips Bit
-
DC Voltage Meter
-
Screw Drivers Phillips & Flat Head (Small Flat Head)
-
Wire Strippers & Crimper's
-
Choice of Connectors +/- Soldering Tools
-
Electrical Tape