RECON 26419 Xenon Strobe Light Kit - Manual (Page 10)

Connecting The Power & Testing.
‐
Connect The 12v+ Wire To Battery
‐
Loom and Secure All Wires Ran Under The Hood & In Cabin
‐
Press The “On/Off” Switch On The Controller. A Single LED Should Light.
‐
Turn Heads 1 & 2 On. The Chosen Strobes For Heads 1& 2 Should Be
Firing. And Led On Controller and Power Supply Should Be Flashing.
‐
Turn Heads 3,4,5&6 On. They Should Be Firing. The Led Should Be
Flashing on Controller & On The Power Supply.
‐
To Change The Flash Pattern, Press The Momentary Switch labeled “Flash
Pattern” Once. This Will Change The Pattern To The Next Pattern In The
Series. Pressing It Again Will Change It To The Next Pattern in The Series.
If This Switch is Not Pressed upon Power Up, The Patterns Will Go
Through All Patterns A Couple Seconds Apart.
At This Point The Install Is Complete. Replace The Seats & Any Trim You Have
Removed During The Install.
• Follow Local Laws And Ordinances.