On to the front – RECON 26419 Xenon Strobe Light Kit User Manual
Page 4
‐
Place The Strobe Inside Drilled 1” Hole.
‐
With The Proper Drill Bit, Pre Drill The Screw Holes Into The Lamp
Housing.
‐
Using The 2 Supplied Screws, Attach The Strobe To The Housing – Check
The Orange Grommet, Make Sure The Face Of The Strobe Is Properly
Sealed To The Housing.
On To The Front
*** I Do Not Recommend Placing The Strobe Inside The High Or Low Beam
Projection Area. This May Cause an Obstruction And Restrict The Lights
Output! If Possible Install In The Turn Signal Area or Away From The
Headlamps. ***
‐
Start by Removing The Housing You Wish To Mount The Strobes. Place On
A Flat Workable Surface For Installation Of Strobe.