RECON 26419 Xenon Strobe Light Kit - Manual (Page 5)

‐
Find A Location Where Strobe Install Is Desired. The Bulb Should Not Be
Installed Within 1” Of Any Other Plastic Part Around The Strobe Itself.
This Will Cause Damage and Possible Fire Hazard.
*** If Your Vehicle Is Equipped With A 3 or 4 Piece Headlamp, You Will be
Required To Drill Into The Outer Housing Using A Slightly Larger Hole Saw
To Fit The Strobe Face. Then Drill The 1” Hole To Mount The Strobe. After
The Strobe Is Mounted *YOU MUST Seal The Housing Around The Strobe,
Using RTV Or Silicone. Failure To Do So Will Create Moisture In The Lenses
and Cause Damage To The Bulbs & Strobe. ***
(See Images Below)
‐
Using The 1” Hole Saw With A Steady Speed, Drill The 1” Hole For The
Strobe.
‐
Once The Hole Is Drilled, Clean Out and Plastic Shavings That Have
Scattered Into The Housing. This Can Be Done By Using A Vacuum, Shop
Air, or Simply By Shaking The Housing Upside Down Until The Shavings
Are Out.
‐
Remove 1 Strobe Out Of Packaging Along With The Supplied Hardware.
‐
Place The Grommet Over The Face Of The Strobe & Align the 2 Screw
Holes.
‐
Fit The Strobe Inside The 1” Hole Previously Cut.
‐
Using A Drill Bit Pre Drill The Screw Holes For The Screws Supplied In The
Kit.
‐
Using A Phillips Bit, Secure The Strobe To The Housing – Be Sure To
Create A Good Seal With The Grommet.