RECON 26419 Xenon Strobe Light Kit - Manual (Page 6)

Running The Strobe Cables
*** It Is Recommended To Ground The Bare Strands Inside Cable To Ground ***
‐
Before Running Wires It Is Important To Inspect The Wires. Understand
There Is A Male & Female Side Of The Cable The Male Side Will Connect
To the Power Supply, The Female End Will Connect To The Strobe.
‐
Based on Where the Controller Is Going to be Mounted, Decided Which
Cables To Use In The Rear (Longer or Shorter Cables). Generally The Rear
Will Require The Longer Cable, But Applications Will Vary.
‐
Staring In The Rear, Run The Male End of the Cable Down Through The
Opening In The Body. I Recommend Taping The Wires Together With
Electrical Tape, This Will Prevent Any Hang Ups While Running The
Cables.
‐
Run The Cables Along The Rear Of The Truck To The Desired Point Of
Entry In The Cab. Be Sure To Secure The Cables, So They Do Not Sag or
Contact Any Moving Parts.
‐
With The Female End Of The Cable, Connect The Supplied Wire
Connectors To The Cable. Following This Required Order.
RED: Outside Aligned With The Raised Line on Clip
BLACK: In Middle
WHITE: Outside Away From Raised Line
‐