Ransburg Evolver Water Applicator 78863-90, 78863-60 - Manual (Page 37)

33
Robot Waterbase Applicator - Maintenance
15. Insure the distance from the face of the robot
plate to the end of the core is per Figure 20.
> Dump line is 1/4" I.D. and paint line is
3/16" I.D.
NOTE
Figure 20: Assembled Hose Length
16. Apply a thin film of SSL-11 petroleum jelly to
barbed end of the fittings. Press the appropriate fit-
ting into the end of the tube by holding the tube by
hand and push in straight with the other hand.
17. Install o-rings on barbed fittings per Figure 21.
Figure 21: Barbed Fittings
18. Re-connect all pilot lines to appropriate fit-
tings.
• Pattern / Fan Air Black, 3/8" OD, Nylon
• Atom Air Natural, 3/8" OD, Nylon
• Trigger Air Green, 3/16" OD, Nylon
• Dump Pilot Red, 3/16" OD, Nylon
• Air Purge Blue, 3/16" OD, Nylon
19. Re-install tubing bundle and robot plate assembly
back into the robot arm. Re-connect all fluid air and
low voltage connections.
20. Before re-installing atomizer to the robot plate,
apply a film of LSCH0009 di-electic lubricant over
entire length of exposed paint and dump line.
Color Code Table
AA-03-01.1 AA-03-01.1