Ransburg Evolver Water Applicator 78863-90, 78863-60 - Manual (Page 14)

10
Robot Waterbase Applicator - Introduction
SPECIFICATIONS
RWA-EFM Series Electrostatic Spray Guns for Highly Conductive Coatings
Robot Manifold Tubing Requirements
Atomizing Air: 3/8" O.D. Nylon
(Natural color)
Pattern Air: 3/8" O.D. Nylon
(Black color)
Paint In: 3/16" I.D. Shielded
Dump Out: 1/4" I.D. Shielded
Trigger Air: 3/16" O.D. Nylon
(Green color)
Dump Pilot: 3/16" O.D. Nylon
(Red color)
Air Purge: 3/16" O.D. Nylon
(Blue color)
Electrical
Operating Voltage: 0-100 kV
0-125 µA
Applicator Nomenclature/Hose Identification:
A Atomization Air (Natural)
F Fan Air (Black)
T Trigger (Green)
DP Dump Pilot (Red)
AP Purge Air (Blue)
TB Trigger Bleed
P Paint In
D Dump Out
Weight
78863-60: 10.2 lbs. (4.6Kg)
78863-90: 10.1 lbs. (4.6Kg)
Length
78863-60: 14.93" (379mm)
(See Figure 3)
78863-90: 12.93" (328mm)
(See Figure 3)
Operating Air Pressures
Atomizing Air: 100 psig max. (6.9 bar)
Fan Air: 100 psig max. (6.9 bar)
Trigger Air: 150 psig max./70 psig min.
(10.3 bar / 4.8 bar)
Purge Air: 200 psig max. (13.8 bar)
Dump Pilot: 150 psig max./70 psig min.
(10.3 bar/4.8 bar)
Fluid Pressure
Max Fluid Pressure: 250 psig
(17.2 bar)
Air Flow Rates/Pressures
(Recommended start point for fan and
atomizing pressures.)
Note: Pressure taken at the cap
Atomizer Air: 27 psig (1.8 bar)
Fan Air: 30 psig (2.1 bar)
Total Air Flow: 17.50 SCFM
(496 SLPM)
Air Purge: 35 psig
AA-03-01.1