General Tools and Instruments CMR35 - Manual (Page 27)

If you know the line voltage of your system, enter it in the “V” window at left (110V is
shown). If you are not sure of the line voltage, measure it by inserting the transmitter’s
black and red probes in a power outlet. Read the value and enter it in the “V” window
at left.
To use the Electric Power Cost Monitor window, the CMR35 system’s transmitter(s) must
be operating in DCA (DC Amperes) or ACA (AC Amperes) measurement mode. If these
conditions are met, the Electric Power Cost Monitor window will automatically be
displayed and updated. Unlike the Monitor, Record and Graph windows, the Electric
Power Cost Monitor window cannot be minimized, maximized or adjusted in size.
The Record menu
ቢ Connect: When checked, indicates interface to receiver is enabled.
ባ Start: When checked, indicates data from transmitter is being logged.
ቤ Pause: When checked, pauses reception of data.
ብ Stop: When checked, stops reception of data.
The four options above also are available from the toolbar below the main menu,
as shown above.
27
CMR35 Manual FINAL4_020911:awb 2/9/11 11:54 AM Page 27