General Tools and Instruments CMR35 - Manual (Page 15)

15
Symbol Description
Transmission ID code (Channel) setting (1 to 6)
When blinking, indicates signal being received from transmitter
Indicates displayed value is memorized maximum or minimum measurement
Indicates displayed value is recalled maximum or minimum measurement
Lit in alarm mode when measured value is higher or lower than alarm setpoint
Lit in 24-hour clock mode
Lit in DC voltage measurement mode
Lit in AC voltage measurement mode
Lit when measured voltage is negative
Lit in diode check mode
Lit in relative measurement mode
Lit in continuity check mode
Display reading
Lit when receiver’s batteries need replacing
Lit when transmitter’s batteries need replacing
Lit when reading memorized maximum or minimum value
Lit when measurement is held
Lit when USB connection to PC is enabled
Lit in alarm mode. When blinking, indicates measured value exceeds
alarm setpoint
Indicates displayed value is transmission span. When multiple transmitters
are used with one receiver, indicates that all transmitters are operating
Lit in frequency measurement mode
Lit in resistance measurement mode
Lit in voltage measurement mode
Lit in current measurement mode
Fig. 4. Symbols used on the receiver’s liquid-crystal display
CMR35 Manual FINAL4_020911:awb 2/9/11 11:54 AM Page 15