Fairbanks FB3000 Highway System Application - Manual (Page 72)

Section 4: Inbound/Outbound Weighment Mode
7/08 72 51188 Rev. 1
4.2.4. Using a Stored Tare Weight
For setting up a Stored Tare, see
Section 3.5.19
.
When using the Stored Tare
function, the empty truck weight is
known by its
Truck/Loop ID
number.
1. The empty truck makes its initial
weighment, then receives a
Truck/Loop ID number .
2. It then gets its load and goes
back to the scale.
3. After entering the scale, the driver gives the operator the Truck/Loop ID
number .
─ The previously programmed tare weight is used to calculate the truck’s current
Net Weight.
The truck leaves and empties its load, then returns later for an unlimited number of
weighments, giving the operator the same
Truck/Loop ID number .
Once the vehicle has a TRUCK (or LOOP ) ID , it can repeat the loading/
weighing/unloading process an unlimited number of times, using the truck’s
empty weight to calculate the load’s
Net Weight.