Fairbanks FB3000 Highway System Application - Manual (Page 52)

Section 3: Highway System Mode of Operation
7/08 52 51188 Rev. 1
3.5.24.3. Adding an Error
1. Click .
2. In the pop-up window, “Enter [a] three character code” for the new error.
─ A new row will generate (in blue) within the spreadsheet window.
3. Enter YES or NO , or fill in the correct response into each of the fields.
FIELD DESCRIPTION
Error Three (3) letter abbreviation for the error.
Description Text sent in email notification that defines the error.
Enabled If disabled (“NO”), the error is ignored and not sent.
Filter If filtered, ignore the error interval if the error contains information about a different
device than that found in the previous same error.
Interval If “0”, the error is sent every time it is found, otherwise the error is sent the first time it
occurs and then again at the specified interval should the error persist.
Param1 Defines the information found in the error. Errors contain 0,1 or 2 parameters.
Param2 Defines further the error information found, if two Params are included in the error.
Last Handled Date and time the error was accessed.
Sent “Error” to
the Following Highlight any recipients to receive the selected error
Enter YES or NO , or
the correct response.