Electronics International CGR-30P - Manual (Page 6)

Contents
(Page 1 of 3)
Warranty/Agreement-------------------------------------------------------------------------------------- 1A
1.0 System Overview ------------------------------------------------------------------------------------- 2
1.1 System Description --------------------------------------------------------------------------- 3
1.1.1 CGR Display ---------------------------------------------------------------------------- 3
1.1.2 EDC-33P --------------------------------------------------------------------------------- 3
1.1.3 Probes, Transducers and Modules --------------------------------------------------- 3
1.1.4 Wiring & Extension Cables ----------------------------------------------------------- 3
1.2 Operational Overview
-------------------------------------------------------------------------------
4
1.3 Installation Overview
---------------------------------------------------------------------------------
4
1.4 Password Protection
----------------------------------------------------------------------------------
5
1.4.1 User Password ------------------------------------------------------------------------------- 5
1.4.2 Maintenance Password --------------------------------------------------------------------- 5
1.4.3 OEM/Experimental Password ------------------------------------------------------------ 6
2.0 Hardware Installation -------------------------------------------------------------------------------- 7
2.1 Important Information and Initial Check Out: ------------------------------------------- 8
2.2 Review the "EDC Wiring Work Sheets:" ------------------------------------------------- 9
2.3 Verify you have all the necessary Probes, Modules, Transducers and Cables: ----- 9
2.4 Install the CGR Display: --------------------------------------------------------------------- 9
2.5 Install the Temperature Probes: ------------------------------------------------------------- 10
2.6 Install the Pressure Transducers: ----------------------------------------------------------- 12
2.7 Install the Interface Circuit for Annunciators -------------------------------------------- 14
2.8 Install the CO Detector, G-Sensor and/or Other Available CGR Options ------- 15
2.9 Install the Shunt: ------------------------------------------------------------------------------ 15
2.10 Install the Fuel Flow Transducer: -------------------------------------------------------- 17
2.11 Install the P-300C Fuel Level Probes (OEM or Experimental) --------------------- 24
2.12 Install the P-300M Fuel Levl Sender: ---------------------------------------------------- 24
2.13 Install the Resistive Fuel Level Module (RFLM-4-X): ------------------------------- 25
2.14 Install the Voice Alarm Control Panel (OEM or Experimental): ------------------- 25
2.15 Install the Intensity Control Pot (Optional): -------------------------------------------- 25
2.16 Install the Master Warning (red) and Caution (yellow) Lights: ----------------------- 26
2.17 Install the EDC-33P: ------------------------------------------------------------------------ 26
3.0 Install the EDC Wire Harnesses and Route Wires ---------------------------------------------- 27
3.1 Attach the three EDC 37-pin wire harnesses to the EDC: ---------------------------- 28
3.2 Connect the EDC Harness to the Temperature Probes: -------------------------------- 28
3.3 Connect the EDC Harness to the Pressure Transdcueres: ----------------------------- 28
3.4 Connect the EDC Harness to the Shunt: -------------------------------------------------- 29
3.5 Connect the EDC Harness to the Fuel Flow Transducer: ----------------------------- 29
3.6 Connect the EDC Harness to the Existing Capacitive Fuel Level System: -------- 29
3.7 Connect the RFLM-4-x Harness to the EDC Connector and to the Resistive
Fuel Level Sensors: ------------------------------------------------------------------------------- 30