Teledyne 3010MA – Paramagnetic oxygen analyzer, no 0-100% range – (superceded) - Manual (Page 38)

Part 1 Control Unit Model 3010MA
Teledyne Analytical Instruments 38
The Analysis Unit is installed adjacent to the Control Unit usually on
the same panel. Refer to Section 3.2 for mounting instructions. An outline
drawing D73635, is included in the Drawings section in the rear of this
manual which contains a panel cutout diagram.
3.5 Rear Panel Connections—Analysis Unit
The Rear Panel of the Analysis Unit is shown in Figure 3-8. The
following connections to the Analysis Unit are made at the rear panel:
•
Gas connections
•
Sample In
•
Sample Vent
•
Pressure Vent (pressure compensation line to Control Unit)
•
Electrical
•
Signal Output
•
Heater Power
Figure 3-8: Analysis Unit Rear Panel