Teledyne 2010B - Split architecture thermal conductivity analyzer - Manual (Page 70)

ii: Part II Teledyne Analytical Instruments
Model 2010B Model 2010B Model 2010B Model 2010B Model 2010B Thermal Conductivity Anal Thermal Conductivity Anal Thermal Conductivity Anal Thermal Conductivity Anal Thermal Conductivity Analyz yz yz yz yzer er er er er
Table of Contents
1 Introduction
1.1 Overview ........................................................................ 1-1
1.2 Connections ................................................................... 1-1
1.3 Electrical Connector Panel ............................................ 1-2
2 Installation
2.1 Unpacking the Analysis Unit .......................................... 2-1
2.2 Mounting the Analysis Unit ............................................ 2-1
2.3 Sample System Design ................................................. 2-2
2.4 Pressure and Flowrate Regulation ................................ 2-3
2.5 VENT Exhaust ............................................................... 2-3
2.6 SAMPLE Gas ................................................................. 2-4
2.7 REFERENCE Gas......................................................... 2-4
2.8 ZERO Gas ..................................................................... 2-5
2.9 SPAN Gas ...................................................................... 2-5
2.10 Electrical Connector Panel ............................................ 2-5
2.11 Signal Wiring Recommendations ................................... 2-7
2.12 Testing the System ......................................................... 2-7
3 Operation
3.1 System Self Diagnostic Test ........................................... 3-1
3.2 Cell Failure Checks ....................................................... 3-2
4 Maintenance
4.1 Routine Maintenance ..................................................... 4-1
4.2 Major Components......................................................... 4-1
4.3 Fuse Replacement......................................................... 4-2
4.4 System Self Diagnostic Test ........................................... 4-3
4.5 Cell, Heater, and/or Thermistor Replacement ................ 4-4
4.5.1 Removing the Cell Compartment ........................ 4-4
4.5.2 Removing and Replacing the Cell Block ............. 4-5
4.5.3 Removing the Heater and/or Thermocouple ........ 4-6
4.5.4 Replacing the Heater and/or Thermister .............. 4-7