Teledyne 2010B - Split architecture thermal conductivity analyzer - Manual (Page 40)

4 Operation Model 2010B
4-6 Part I Teledyne Analytical Instruments
Use < > arrows to blink
AUTO—CAL
, and press Enter . A new screen for
ZERO/SPAN set appears.
ZERO in Ød Øh off
SPAN in Ød Øh off
Press < > arrows to blink
ZERO
(or
SPAN
), then press Enter again.
(You won’t be able to set
OFF to ON if a zero interval is entered.) A Span
Every ... (or Zero Every ...) screen appears.
Zero schedule: OFF
Day: Ød Hour: Øh
Use
∆∆∆∆∆∇
arrows to set an interval value, then use < > arrows to move to the
start-time value. Use
∆∆∆∆∆∇
arrows to set a start-time value.
To turn
ON the SPAN and/or ZERO cycles (to activate AUTO–CAL):
Press System again, choose
AUTO–CAL
, and press Enter again. When the
ZERO/SPAN values screen appears, use the < > arrows to blink the ZERO
(or
SPAN) and press
Enter to go to the next screen. Use < > to select
OFF/
ON field. Use ∆∆∆∆∆∇
arrows to set the
OFF/ON field to ON. You can now turn
these fields
ON because there is a nonzero span interval defined.
4.3.3 Password Protection
Before a unique password is assigned, the system assigns
TAI by default.
This password will be displayed automatically. The operator just presses the
Enter key to be allowed total access to the instrument’s features.
If a password is assigned, then setting the following system parameters can
be done only after the password is entered: alarm setpoints, assigning a new
password, range/application selections, and curve algorithm linearization.
(APPLICATION and ALGORITHM are covered in the programming section.)
However, the instrument can still be used for analysis or for initiating a self-test
without entering the password. To defeat security the password must be
changed back to
TAI.
NOTE: If you use password security, it is advisable to keep a copy of
the password in a separate, safe location.