Teledyne 2010B - Split architecture thermal conductivity analyzer - Manual (Page 4)

Teledyne Analytical Instruments iv
Model 2010B
Specific Model Information
The instrument for which this manual was supplied may incorporate one or more
options not supplied in the standard instrument. Commonly available options are listed
below, with check boxes. Any that are incorporated in the instrument for which this
manual is supplied are indicated by a check mark in the box.
Instrument Serial Number: _______________________
Options Included in the Instrument with the Above Serial Number:
❑ ❑ ❑ ❑ ❑ C: Auto Calibration valves (zero/span/sample) built-in gas control
valves are electronically controlled to provide synchronization
with the analyzer’s operations.
❑ ❑ ❑ ❑ ❑ G: Stainless steel cell block with nickel filaments and Stainless
Steel fittings and tubing.
❑ ❑ ❑ ❑ ❑ H: Stainless steel cell block with gold filaments for corrosive gas
streams and Stainless Steel fittings and tubing.
❑ ❑ ❑ ❑ ❑ K: 19" Rack Mount option with one or two analyzer Control
Units installed and ready to mount in a standard rack.
❑ ❑ ❑ ❑ ❑ K2: 19" Rack Mount option with two Control Units mounted.
❑ ❑ ❑ ❑ ❑ K3: 19" Rack Mount option with one Control Unit mounted and a
blank cover installed in the second Control Unit location.
❑ ❑ ❑ ❑ ❑ L: Gas selector panel consisting of sample/ref flow meters and
control valves for metering input of sample/calibrations support
gases.
❑ ❑ ❑ ❑ ❑ F: Flame Arrestors for Class 1, Div. 1, Groups C/D service.
❑ ❑ ❑ ❑ ❑ P: Flame Arrestors for Class 1, Div. 1, Groups C/D service, and
Auto Cal valves option (Ref. C above) and GP use.
❑ ❑ ❑ ❑ ❑ Q: Flame Arrestors for Group B (hydrogen) service, and Auto Cal
valves option (Ref. C above)
❑ ❑ ❑ ❑ ❑ O: Flame Arrestors for Group B (hydrogen)
❑ ❑ ❑ ❑ ❑ R: Sealed Reference Cell