PSA PIN388D/PIN388L Installer Manual User Manual

Page 12

PINKERTON Installer Manual

PINKERTON

PERATION

EYPAD

UNCTIONS

After a code is entered or the

key is pressed, you have 10

seconds to select the operation you wish to perform. During this
time all 8 Zone lights will flash to indicate that a key should be
pressed. If no key is pressed within 10 seconds, the keypad will
revert to idle mode. Enter the code to start again.

The

key is always used as "clear key" to abort the current operation.

PERATION OF ALL KEYS

PANIC

Key

Enter a User Code followed by

or enter

to trigger the Panic function. The Panic

function can trigger the siren, strobe light or dialler as programmed by your installer at address
088.

DURESS

Key

Enter a User Code followed by

or enter

to trigger the Duress function. The Duress

function can trigger the siren, strobe light or dialler as programmed by your installer at address
086.

TEST

Key

Enter a User Code followed by

or enter

to trigger the Test function. The Test function

is used to test the dialler by sending a test transmission to the programmed telephone numbers.
This function is only available if your system is programmed to report alarms to a monitoring
station.