PROLiNK WNR1008 User Manual - Manual (Page 25)

PROLiNK® WNR1008 www.prolink2u.com
Version 1.00 22 English
Data Rate Select the data rate form the pull-down list.
Comment Enter a description for the device.
Apply Changes After completing the settings on this page, click Apply changes button to save the settings.
Reset Click Reset to restore to default values.
Set Security
Enable the WDS function and then click Set Security button to set up the WDS security.
Encryption: Select the encryption type None, WEP 64 bits, WEP 128 bits, and WPA2 (AES) from the pull-down
menu.
WEP Key Format: For WEP 64 bits and WEP 128 bits encryption type, the selection of WEP Key Format are Hex
and ASCII.
WEP Key: If select Hex if you are using hexadecimal numbers (0-9, or A-F). Select ASCII if you are using ASCII
characters (case-sensitive).
 Hexadecimal (WEP 64 bits): 10 Hex characters (0~9, a~f).
 Hexadecimal (WEP 128 bits): 26 Hex characters (0~9, a~f).
 ASCII (WEP 64 bits): 5 ASCII characters (case-sensitive).
 ASCII (WEP 128 bits): 13 ASCII characters (case-sensitive).
Pre-Shared Key Format: The Pre-shared Key Format will be enabled when WPA (TKIP) and WPA2 (AES)
encryption be selected. There are two formats for choice to set the Pre-shared key, Passphrase and Hex (64
characters). If Hex is selected, users will have to enter a 64 characters string. For easier configuration, the
Passphrase (at least 8 characters) format is recommended.
Pre-Shared Key: Pre-Shared-Key serves as a password. Users may key in 8 to 63 characters string to set the
passwords or leave it blank, in which the 802.1x Authentication will be activated. Make sure the same password is
used on client's end.
Show Statistics
Click to show the current WDS AP table. This table shows the MAC address, transmission packets and errors,
reception packets and Tx Rate (Mbps) counters for each configured WDS AP.
PROLiNK_WNR1008