PROLiNK WNR1008 User Manual - Manual (Page 16)

PROLiNK® WNR1008 www.prolink2u.com
Version 1.00 13 English
Advanced Routing
If you connect several routers with this Wireless Router, you may need to set up a predefined routing rule to have
more effective network topology/traffic, this is called static route between those routers and the Wireless Router.
Item / Function Descriptions / Instructions
Enable Dynamic
Route Check to enable the dynamic route function.
NAT: Select to enable the network address translation function.
Transmit: Select to use the Routing Information Protocol, the function will select the packet transmitting route that
pass through least routers.
Receive: Select to use the Routing Information Protocol, the function will select the packet receiving route that pass
through least routers.
Enable Static Route IP address: Enter the Gateway IP address in the field.
Subnet Mask: Enter the Gateway subnet mask here.
Gateway: Enter the gateway name or domain name here.
Metric: The route with the lowest metric is the preferred route.
Interface: Select to use LAN or WAN as the physical interface from where the packets will be sent.
Destination The network address of the destination LAN segment. When a packet with destination IP address that matches to this
field, it will route to the device set in the Route Gateway field.
Range Select Host or Net from the pull-down menu. If select Net, please enter the Netmask in the following column.
IP address Enter the Gateway IP address in the field.
Interface You can
Comment Enter note or remark here.
Apply After completing the settings on this page, click Apply button to save the settings.
Reset Click to discard current setting.