PROLiNK WNR1008 User Manual - Manual (Page 19)

PROLiNK® WNR1008 www.prolink2u.com
Version 1.00 16 English
User can set up the multiple AP here.
Network Type If the mode be set to AP or Client mode that the network type can be set to Infrastructure or Ad hoc.
SSID
A SSID (Service Set Identifier) is referred to a network name because essentially it is a name that identifies a wireless
network (case-sensitive).
Channel Width Select 20MHz/40MHz channel width, the channel number will be form 5~11 and auto; Select 20MHz channel width
the channel number will be form 1~11 and auto. Default is 20MHz/40MHz.
Channel Selection The channel number base on the channel width you select.
Broadcast SSID Enabled: This wireless AP will broadcast its SSID to stations.
Disabled: This wireless AP will not broadcast its SSID to stations. If stations want to connect to this wireless AP, this
AP’s SSID should be known in advance to make a connection.
WMM The WiFi Multiple Media function is available under 2.4GHz (B), 2.4GHz (G) and 2.4GHz (B+G) band, and it is disabled
under 2.4GHz (N), 2.4GHz (G+N) and 2.4GHz (B+G+N) band.
Data Rate There are several data rate that you can select from the pull-down menu.
Associated Clients
Click Show Active Clients button to show all the listed active clients.
Enable Mac Clone
(Single Ethernet
Client)
This function will be enabled under Client mode.