PERKO 0203 - Manual

Ref
erence Line
Drill for #8
Screw
Drill for #8
Screw
MOUNTING TEMPLATE #1
0203 Series L.E.D.
Cat. No. 0203 Series L.E.D. 25°
Angled Docking Light
The above lights are not designed for navigational
use and are not for use below the waterline.
MOUNTING INFORMATION
Read all instructions before proceeding.
1). These instructions show the orientation of the light
after the proper location has been determined.
2). These lights are supplied with the proper circuit for
operation on a nominal 12 volt system.
3). These lights contain no user serviceable
components.
4). Draw a 6 inch long reference line through the
center of the selected mounting location.
5). Cut out the mounting template to the right. Tape it
on the mounting surface such that the reference
line (drawn above) passes through the exact
center of the template.
6). Drill three holes through the template as indicated
for the #8 mounting screws.
7). Drill a pilot hole inside the area to be cut out. Using
a jig saw, cut out the 2-1/4” x 2-1/2” hole to
accommodate the body as indicated by the dotted
line. Alternatively, drill a 2-1/4” round hole at a 25°
angle to the surface.
8). Wiring should be done by a qualified marine
electrician. Attach supply connections to the light,
making sure to wire in accordance with both
A.B.Y.C. Standard E-9* and U.S. Coast Guard
Safety Standards for Boat Electrical Systems
(33CFR 183)* Observe polarity.
9). Attach the light to the mounting surface using #8
mounting screws.
* The above referenced standards can be obtained
from:
(1). American Boat & Yacht Council, Inc.
613 Third Street, Suite 10
Annapollis, MD 21403
(2). U.S. Coast Guard
Washington, D.C. 20593
(or your local C.G. office)
10/08
0203INS1
Perko, Inc.
16490 N.W. 13th Avenue
Miami, FL 33169-5707
www.perko.com
This is a 3/4”
dia. circle in
order to scale
internet printed
templates
Ref
erence Line
Drill for #8
Screw
Drill for #8
Screw
MOUNTING TEMPLATE #2
0203 Series L.E.D.