PERKO 0602 - Manual

4). Cut out the mounting template. Tape it on the mounting surface such that the reference
line (drawn above) is directly underneath the reference line marked on the template, and
the arrow on the template points ahead (not astern).
5). Drill mounting holes as indicated. Mounting screw length should be selected to protrude
at least 3/4 inch below light base for secure installation.
6). Each light is identified with a colored mark (Red/Green) as the lens is clear. If the mark is
absent, attach power to light leads to identify light.
7). Attach supply connections to the light, making sure to wire in accordance with both
A.B.Y.C. Standard E-9* and U.S. Coast Guard Safety Standards for Boat Electrical
Systems (33 CFR 183)*. These lights are polarity sensitive. Connect red lead to positive
and black lead to negative.
8). Mount the light on the correct side of the boat in accordance to Diagram #1. Note that
there are thin reference marks around the outside of the black base that must be aligned
with the reference line (drawn in step #3) for final accuracy of mounting orientation.
9). Recheck that the red shows port and green shows starboard.
* The above referenced standards can be obtained from:
1) American Boat and Yacht Council, Inc 2) U.S. Coast Guard
3069 Soloman’s Island Road Washington, D.C. 20593
Edgewater, Maryland 21037 (or your local C.G. Office)
5/05 PERKO, INC.
0602INS1 16490 N.W. 13th Avenue
Miami, FL. 33169-5707
www.perko.com
M OUNTING T EMPLATE
F IG . 0602 S ERIES S IDELIGHTS
Ahead
Reference Line
Red
Green
Vertical Mounting
Surfaces
Diagram #1
Bow Stern
Fig. 0602 Series Sidelight Instructions
The above lights are designed for use on power driven vessels under 20
meters (65.6 ft.) in length, operating on a nominal 12 volt or 24 volt system.
In order to comply with the ‘72 COLREGS and the U.S. Inland Rules, the following must be
adhered to:
MOUNTING INFORMATION
Read all instructions before proceeding.
1). These instructions show the orientation of the lights after the proper mounting location has
been determined. For proper light selection, positioning and configuration, refer to
A.Y.B.C. Standard A-16*, the ‘72 COLREGS*, and the U.S. Inland Navigation Rules*.
These lights are supplied complete for 12 volt systems or for 24 volt systems. (See the
following chart):
2). These lights are designed to be mounted on a vertical surfaces that are parallel to the cen-
terline of the boat. The mounting surface must provide a minimum of 10 inches of surface
ahead of the light. (See Diagram #1)
3). Draw a 6 inch long horizontal reference line through the center of the selected mounting
location and parallel to the centerline of the boat.
System Max
Cat. No. Voltage Visibility Vessel Size
0602DP1
12 2 Mile
Up to 20
0602001 Meters (65.6 Ft.)
0602DP2
24 2 Mile
Up to 20
0602002 Meters (65.6 Ft.)
Cut out Template on Dotted Line
10” Mounting surface
ahead of light .
(See Instruction #2)
USCG APPROVAL
33 CFR 183.810
Visibility: 2nm
Tested By: IMANNA Labs.
Date: 8/26/03 & 11/13/03
Meets ABYC A-16