PERKO 0939 User Manual
Mounting template
Cat. No. 093900112V Stern Light
Cat. No. 0939DP112V Stern Light
Cat. No. 0939DP332V Stern Light
The above lights are designed for use on sail or power driven vessels under 20 meters (65.6 ft.) in length operating on a
nominal 12 volt or 32 volt system. NOTE: PERKO series 0939 used with a 32V bulb is not certified in accordance with 33 CFR
183.810 as this light is intended for replacement use only on appropriate vessels constructed prior to 11/1/03. All previous certifica-
tions apply. In order to comply with the ‘72 COLREGS* and the U.S. Inland Rules*, the following must be adhered to:
MOUNTING INFORMATION
Read all instructions before proceeding.
1).
These instructions show the orientation of the light after the proper location has been determined. For proper light selection, positioning and configuration,
refer to the A.B.Y.C. Standard A-16*, the ‘72 COLREGS*,and the U.S. Inland Navigation Rules*.
2).
This light is supplied with the proper bulb for operation on a nominal 12 volt system or a nominal 32 volt system. Use PERKO Cat. No. 0070DP0CLR, 12V,
10W bulb for a 12 volt system (Stern Light Cat. No. 093900112V or 0939DP112V) or PERKO Cat. No. 0070002CLR bulb for a 32 volt system (Stern Light
Cat. No. 0939DP332V).
3).
These Lights are designed to be mounted on a vertical surface that is perpendicular to the centerline of the boat and facing astern.
4).
Draw an 8 inch long horizontal reference line through the center of the selected mounting location.
5).
Cut out the mounting template below. Tape it on the mounting surface such that the reference line (drawn above) passes through the exact center of the
template.
6).
Drill two holes through the template as indicated for the mounting screws.
7).
Drill a 2-1/8 inch hole to accommodate socket holder as indicated.
8).
Attach supply connections to the light, making sure to wire in accordance with both A.B.Y.C. Standard E-9* and U.S. Coast Guard Safety Standards for Boat
Electrical Systems (33 CFR 183)*
* The above refenced standards can be obtained from:
1).
American Boat & Yacht Council, Inc.
2).
U.S. Coast Guard
3069 Solomans Island Road
Washington, D.C. 20593
Edgewater, Maryland 21037
(or your local C.G. office)
6/04
0939INS1
MOUNTING TEMPLATE
Cat Nos.
093900112V
0939DP112V
0939DP332V
PERKO,INC.
16490 N.W. 13th. Avenue
Miami, FL 33169-5707
www.perko.com
USCG APPROVAL
33 CFR 183.810
Visibility: 2nm
Tested By: IMANNA Labs.
Date: 2/4/03
Meets ABYC A-16
12V