PERKO 0170WTW - Manual

Fig. 1
Fig. 2
1. Masthead White
2. Port Red
3. Starboard Green
4. Stern White
5. Towing Yellow
63 5MM
(2.5 Inch)
Center
5MM
Diamter
Screws
Cat. No. 0170 L.E.D. Series Navigation Lights
For use on sail or power driven vessels under 20 meters (65.6 ft.) in length.
Mounting:
A). Consider the location of the light to give:
i) Correct positioning of the light on the boat and
ii) The most convenient position for cleaning.
B). Mount the red (port) and green(starboard) sidelights accurately vertical in
the same thwartship plane and at the same height above the waterline at
least one meter below the masthead light.
C). Mount the white masthead light vertical on the centerline clear of all other
lights at least 1 meter above the sidelights.
D). Mount the white stern light vertical on the centerline and high enough not
to be obscured by a following sea.
Installation Instructions:
A). Unscrew and remove lens assembly.
B). Observe voltage and polarity of supply connections. Strip supply cable
ends and connect to pigtail leads on back of light.
C). Mount base assembly using only round head or pan head screws (screw
diameter 5mm or No. 10 wood screw) DO NOT use counter sunk screws.
D). Locate the lens assembly on the base. Tighten mounting screw.
Electrical Connections:
Always use cable of sufficent size to ensure total voltage drop is less than 0.5
volt for a nominal 12 volt installation or 1 volt for a nominal 24 volt installation.
Recommended minimum cable size 1.5mm
2 (No.16AWG).
Cleaning:
Use only fresh water and mild detergents to clean.
12/08
0170INS3
PERKO, INC.
16490 N.W. 13th Avenue
Miami, FL 33164-5707
www.perko.com
USCG APPROVAL
33 CFR 183.810
Visibility: Multiple
Tested By: IMANNA Labs.
Date: Varies
Meets ABYC A-16
0170 L.E.D. Series Certifications
12V
Light Color Visibility Test Date
Masthead White 3nm 8/30/05
Port Red 2nm 7/29/03
Starboard Green 2nm 8/26/03
Stern White 2nm 7/29/03
Towing Yellow 2nm 7/29/03
Fig. 1
Fig. 2
1. Masthead White
2. Port Red
3. Starboard Green
4. Stern White
5. Towing Yellow
63 5MM
(2.5 Inch)
Center
5MM
Diamter
Screws
Cat. No. 0170 L.E.D. Series Navigation Lights
For use on sail or power driven vessels under 20 meters (65.6 ft.) in length.
Mounting:
A). Consider the location of the light to give:
i) Correct positioning of the light on the boat and
ii) The most convenient position for cleaning.
B). Mount the red (port) and green(starboard) sidelights accurately vertical in
the same thwartship plane and at the same height above the waterline at
least one meter below the masthead light.
C). Mount the white masthead light vertical on the centerline clear of all other
lights at least 1 meter above the sidelights.
D). Mount the white stern light vertical on the centerline and high enough not
to be obscured by a following sea.
Installation Instructions:
A). Unscrew and remove lens assembly.
B). Observe voltage and polarity of supply connections. Strip supply cable
ends and connect to pigtail leads on back of light.
C). Mount base assembly using only round head or pan head screws (screw
diameter 5mm or No. 10 wood screw) DO NOT use counter sunk screws.
D). Locate the lens assembly on the base. Tighten mounting screw.
Electrical Connections:
Always use cable of sufficent size to ensure total voltage drop is less than 0.5
volt for a nominal 12 volt installation or 1 volt for a nominal 24 volt installation.
Recommended minimum cable size 1.5mm
2 (No.16AWG).
Cleaning:
Use only fresh water and mild detergents to clean.
12/08
0170INS3
PERKO, INC.
16490 N.W. 13th Avenue
Miami, FL 33164-5707
www.perko.com
USCG APPROVAL
33 CFR 183.810
Visibility: Multiple
Tested By: IMANNA Labs.
Date: Varies
Meets ABYC A-16
0170 L.E.D. Series Certifications
12V
Light Color Visibility Test Date
Masthead White 3nm 8/30/05
Port Red 2nm 7/29/03
Starboard Green 2nm 8/26/03
Stern White 2nm 7/29/03
Towing Yellow 2nm 7/29/03