PERKO 0609 User Manual
Mounting templates
![background image](/manuals/341076/1/background.png)
Fig. Nos. 0609 Series L.E.D. Swivel Berth Light
The above lights are not designed for navigational use.
MOUNTING INFORMATION
Read all instructions before proceeding.
1). These instructions show the orientation of the light after the proper
mounting location has been determined.
2). These lights are supplied with the proper circuit for operation on a
nominal 12 volt system. Maximum draw is 9 watts.
3). These lights contain no user serviceable components.
4). Draw a 8-1/2 inch long reference line through the center of the
selected mounting location.
5). Cut out the appropriate mounting template below.Tape it on the
mounting surface such that the reference line (drawn above) passes
through the exact center of the template.
6). Drill four holes through the template as indicated for the #8 mounting
screws and holes 1/4” diameter to accommodate the wiring as
indicated on template.
7). Attach the light brackets to the mounting surface using #8 mounting
screws.
8). To wire units supplied without integral switch:
On white only fixtures:
• Connect leads to switched power (on/off). Observe polarity.
• This fixture can be connected to an external, 12 volt marine-
service dimmer.
On white/red fixtures:
• Connect leads to switched power using a SPDT (center off) switch.
Observe polarity. (See wiring diagram).
• This fixture can be connected to an external, 12 volt, marine-service
dimmer.
9). To wire units supplied with integral switch:
• Connect leads to switched power (on/off). Observe polarity.
• This fixture can be connected to an external, 12volt marine-service
dimmer.
10). Mount the light body to the brackets and tighten the end screws.
* The above referenced standards can be obtained from:
(1). American Boat & Yacht Council, Inc.
613 Third Street, Suite 10
Annapollis, MD 21403
(2). U.S. Coast Guard
Washington, D.C. 20593
(or your local C.G. office)
Perko, Inc.
16490 N.W. 13th Avenue
Miami, FL. 33169-5707
www.perko.com
10/11
0609INS1
Cut out Template on Dotted Line
#
This is a 3/4”
circle in order
to scale internet
printed
templates
Cut out Template on Dotted Line
#
Drill 1/4” Dia. holes for electric wires
Drill for #8 Screws (2) places
Fig 0609
without Switch
shown
MOUNTING TEMPLATES
Drill 1/4” Dia. holes for electric wires
Drill for #8 Screws (2) places
For Cat. Nos. 0609W0012V & 0609WR012V
For Cat. Nos. 0609W0S12V & 0609WRS12V
FOR FIG. 0609 WITHOUT SWITCH
FOR FIG. 0609 WITH SWITCH
Wiring Diagram