PERKO 0969 User Manual
PERKO Lighting

CAT. NOS. 0884, 0885 OR 0886 SEARCHLIGHTS WITH
CAT. NO. 969 CONTROL ASSEMBLY
ASSEMBLY AND INSTALLATION INSTRUCTIONS
NOTE: STOP COLLAR ASSEMBLY ON 1 INCH CONTROL TUBE IS
FACTORY PRE-SET AT 3-9/16 INCHES. DO NOT LOOSEN.
1.
Place Head Assembly (Box #1) on flat area with lens down. Remove pinion gear from the
control assembly (Box #2). With “O” ring seal in place, insert the control assembly through the
base into the main fork with the twist lever handle pointing straight up.
2.
Important - to prevent leakage, apply pressure on “O” ring seal (by pushing control assembly
into the base) while tightening 3 set screws in fork hub.
3.
Replace pinion gear and tighten set screw.
4.
Insert electric wire through searchlight base and tighten packing gland.
5.
Remove twist lever handle assembly and ceiling plate from control tube and rod.
6.
Drill holes in deck, per template on reverse side.
7.
Place searchlight assembly through the cabin roof in proper position and thru-bolt with 5/16
inch machine screws (not supplied).
8.
Install ceiling plate and twist lever handle assembly.
9.
Wiring must be according to applicable standards and performed by a qualified marine electri-
cian.
5/05
969INS1
PERKO, INC.
16490 N.W. 13th AVENUE
MIAMI, FL 33169-5707
www.perko.com
Document Outline
- 0969_Instuctions.pdf
- Fig. 969 Instruction 7 inches.pdf
- Fig 969 Instruction 8 inches v6.pdf
- Fig 0969 Control Assembly.pdf