PERKO 1345 User Manual
PERKO Lighting
In order to comply with ‘72 COLREGS and the U.S. Inland Rules, the following must be
adhered to:
MOUNTING INFORMATION
Read all instructions before proceeding.
1).
For proper light selection, positioning and configuration, refer to A.B.Y.C. Standard A-16*,
the ‘72 COLREGS*, and the U.S. Inland Rules*.
2).
These lights are designed to be mounted on a horizontal surface. Horizontal rotation of
these lights is unimportant, as all-round lights have 360° horizontal arc of visibility.
3).
Cut out the template below. Tape it to the mounting surface.
4).
Drill two holes through the template to accommodate #8 round or pan head mounting
screws. Drill one 3/8 inch hole to accommodate the electrical supply wires.
5).
Attach supply connections to the light, making sure to wire in accordance with both A.B.Y.C.
Standard E-9* and U.S. Coast Guard Safety Standards for Boat Electrical Systems (33 CFR
183)*. If supplied with two black leads, these lights are not polarity sensitive; otherwise
connect red to positive and black to negative electrical supply.
6).
Mount the base in accordance with the template.
7).
Make sure the light is vertical during operation, in order to assure compliance with the
technical details of the regulations and employ the “Reduced Glare” feature of this optical
system.
8).
These lights use white L.E.D.’s and therefore are not serviceable. The lens/globe is
permanently sealed and cannot be opened. A warm pole during operation is normal.
*The above referenced standards can be obtained from:
(1).
American Boat & Yacht Council, Inc.
(2). U.S. Coast Guard
613 Third Street, Suite 10
Washington, D.C. 20593
Annapolis, MD 21403
(or your local C.G. Office)
PERKO, INC.
1344INS1
16490 N.W. 13th Avenue
12/08
Miami, FL 33169-5707
www.perko.com
MOUNTING Template
Cat Nos.
1344DP1WHT
1344001WHT
1345DP1WHT
1345001WHT
Cat. No. 1345 Series L.E.D.
White All-Round Lights
These lights are designed for use on
POWER driven vessels under 20
meters (65.6 ft.) in length operating on a nominal 12 volt system.
Cat. No. 1344 Series L.E.D.
White All-Round Lights
These lights are designed for use on
SAIL or POWER driven vessels
under 20 meters (65.6 ft.) in length operating on a nominal 12 volt system.
USCG APPROVAL
33 CFR 183.810
Visibility: 2nm
Tested By: IMANNA Labs.
Date: Varies
Meets ABYC A-16
Approval Dates
Fig. 1344- 6/8/06
Fig. 1345 - 11/9/06
In order to comply with ‘72 COLREGS and the U.S. Inland Rules, the following must be
adhered to:
MOUNTING INFORMATION
Read all instructions before proceeding.
1).
For proper light selection, positioning and configuration, refer to A.B.Y.C. Standard A-16*,
the ‘72 COLREGS*, and the U.S. Inland Rules*.
2).
These lights are designed to be mounted on a horizontal surface. Horizontal rotation of
these lights is unimportant, as all-round lights have 360° horizontal arc of visibility.
3).
Cut out the template below. Tape it to the mounting surface.
4).
Drill two holes through the template to accommodate #8 round or pan head mounting
screws. Drill one 3/8 inch hole to accommodate the electrical supply wires.
5).
Attach supply connections to the light, making sure to wire in accordance with both A.B.Y.C.
Standard E-9* and U.S. Coast Guard Safety Standards for Boat Electrical Systems (33 CFR
183)*. If supplied with two black leads, these lights are not polarity sensitive; otherwise
connect red to positive and black to negative electrical supply.
6).
Mount the base in accordance with the template.
7).
Make sure the light is vertical during operation, in order to assure compliance with the
technical details of the regulations and employ the “Reduced Glare” feature of this optical
system.
8).
These lights use white L.E.D.’s and therefore are not serviceable. The lens/globe is
permanently sealed and cannot be opened. A warm pole during operation is normal.
*The above referenced standards can be obtained from:
(1).
American Boat & Yacht Council, Inc.
(2). U.S. Coast Guard
613 Third Street, Suite 10
Washington, D.C. 20593
Annapolis, MD 21403
(or your local C.G. Office)
PERKO, INC.
1344INS1
16490 N.W. 13th Avenue
12/08
Miami, FL 33169-5707
www.perko.com
MOUNTING Template
Cat Nos.
1344DP1WHT
1344001WHT
1345DP1WHT
1345001WHT
Cat. No. 1345 Series L.E.D.
White All-Round Lights
These lights are designed for use on
POWER driven vessels under 20
meters (65.6 ft.) in length operating on a nominal 12 volt system.
Cat. No. 1344 Series L.E.D.
White All-Round Lights
These lights are designed for use on
SAIL or POWER driven vessels
under 20 meters (65.6 ft.) in length operating on a nominal 12 volt system.
USCG APPROVAL
33 CFR 183.810
Visibility: 2nm
Tested By: IMANNA Labs.
Date: Varies
Meets ABYC A-16
Approval Dates
Fig. 1344- 6/8/06
Fig. 1345 - 11/9/06