DoorKing 1808 Telephone Access Plus - Manual (Page 54)

Page 54 1810-162-J-1-12
4.1.3 Dial-Connect (1816 intercom)
To use the dial-connect feature, the guest simply presses a two-digit directory code (01-23) on the
Access Plus unit’s keypad. The unit will automatically connect to the resident phone programmed
under the directory code that was entered on the keypad. Once the call is answered, the person
called may grant access by pressing the programmed tone open number or they can press the hang
up number (2.4.8) to disconnect the call without granting access.
4.1.4 Dial-Out (auto-dial) Phone Numbers
To use the dial-out phone number feature, the guest simply presses a two-digit directory code (24-50)
on the Access Plus unit’s keypad. The unit will automatically dial out the phone number programmed
under the directory code that was entered on the keypad (section 2.5.1). Once the call is answered,
the person called may grant access by pressing the programmed tone open number or they can
press the hang up number (2.4.10) to disconnect the call without granting access.
4.1.5 Access Codes
The simple access codes (five-digit entry code on the Access Plus unit’s keypad) will operate either
relay 1 or relay 2 depending on which relay they have been programmed to activate (2.6.1).
Keypad device access codes will operate the relay that they have been programmed to operate
(2.6.1).
To use a keypad access code:
1. Press # then enter the access code [# _ _ _ _ _ (beeeeeep)]
When the access code is entered on the keypad, the system will check its memory to see if the code
is programmed and will also check any time zone restrictions that may have been programmed for
the specific code that was entered.
If the access code is a temporary code, the system will check the clock/calendar to determine if the
current day falls within the programmed temporary access code boundaries (section 2.6.7).