DoorKing 1808 Telephone Access Plus - Manual (Page 43)

1810-162-J-1-12 Page 43
2.5 Directory Codes
2.5.1 Directory Codes 01 – 23 1816 Intercom Relay Programming
Default Value is 0 (Directory codes 01-23 are turned off)
Directory codes 01-23 are pre-set to dial relay numbers and telephone intercom lines associated with
the 1816 system. Use this programming step if the 1816 Access Plus module is attached to the 1808
or 1810 Access Plus System.
1. Press * 4 1 and enter the MASTER CODE. [* 4 1 _ _ _ _ (beep)]
2. Enter a two-digit directory code (01-23) then press *. [ _ _ (beep)]
3. Enter 0 * (beep) to turn the directory code OFF, or enter 1 * (beep) to turn the directory code
ON.
4. Repeat steps 2 and 3 to turn other directory codes either ON or OFF.
5. Press 0# TOGETHER to end. [0# (beeeeeep)]
2.5.2 Directory Codes 24 – 50 Dial Phone Number
The Access Plus system has the capability of operating as an auto-dialer and can store up to 27
phone numbers in its memory. When a visitor enters a directory code on the system keypad, the
Access Plus unit will call the phone number programmed under the specific directory code number.
Valid directory codes that can be used for the auto-dialer function are 24 through 50 only.
1. Press * 4 1 and enter the MASTER CODE. [ * 4 1 _ _ _ _ (beep)]
2. Enter a two-digit directory code (24-50) then press *. [ _ _ * (beep)]
3. Enter the phone number (up to 20 digits) then press *. [ _ _ _ _ _ _ _ _ _ _ _ * (beep)]
4. Repeat steps 2 and 3 to enter additional numbers.
5. Press 0# TOGETHER to end. [0# (beeeeeep)]
2.5.3 Delete Phone Number from Directory Codes 24 - 50
This programming sequence deletes individual directory code dial-out phone numbers from the
system memory.
1. Press * 4 2 and enter the MASTER CODE. [ * 4 2 _ _ _ _ (beep)]
2. Enter a two-digit directory code (24-50) of the phone number you want to delete then press *.
[ _ _ * (beep)]
3. Repeat step 2 to delete additional numbers.
4. Press 0# TOGETHER to end. [0# (beeeeeep)]
2.5.4 Delete All Phone Numbers from Directory Codes 24 - 50
This programming sequence will delete all directory code dial-out phone numbers stored in the
system memory.
WARNING: once started, all phone numbers will be erased.
1. Press * 4 3 and enter the MASTER CODE. [ * 4 3 _ _ _ _ (Beep)]
2. Press 9 9 9 9 then press *. [ 9 9 9 9 * (beep)]
3. The programming sequence will end itself automatically. [beeeeeep]